Sheared screws and faulty threads on metal

The ideal and inexpensive way to repair high-strength and heat-resistant metal links with presto adhesive steel.

Also suitable for use on:
Lawnmowers, cast iron, metal parts and engine components

You will need these products

Here’s how

To repair a sheared screw or damaged oil pan threads, you first have to remove them.

Drill into the screw set to make a hole 2-3 mm larger than the new screw thread of the new screw. Finely clean the hole.

Thoroughly mix hardener with the adhesive steel, paying close attention to the instructions. The mixing ratio has to be exact because it is an epoxy system.

Thickly pour the mixture into the hole. It is important to avoid any air bubbles. After filling the hole, repeatedly prick the adhesive steel with a needle to thicken and seal the material, if needed.

Pre-drill the hardened adhesive steel to the appropriate size according to the thread diameter. Then use a thread cutter to cut a new thread and your repaired oil pan is ready.

News

A thorough preparation is the essence of painting. One of the most important steps in painting: the thorough removal of dirt, oil, grease, silicone,...

Read more

Ideas

Blattsilber & Beton: Wie kommen die denn ins Nest? Ganz einfach: Wir haben eine Fertigbetonmischung in ausgeblasene Eierschalen gefüllt und die...

Read more

These magical lanterns will get a lot of attention. You’ll find similar decorations that really catch the eye with a little colour, at flea markets or...

Read more