Sheared screws and faulty threads on metal

The ideal and inexpensive way to repair high-strength and heat-resistant metal links with presto adhesive steel.

Also suitable for use on:
Lawnmowers, cast iron, metal parts and engine components

You will need these products

Here’s how

To repair a sheared screw or damaged oil pan threads, you first have to remove them.

Drill into the screw set to make a hole 2-3 mm larger than the new screw thread of the new screw. Finely clean the hole.

Thoroughly mix hardener with the adhesive steel, paying close attention to the instructions. The mixing ratio has to be exact because it is an epoxy system.

Thickly pour the mixture into the hole. It is important to avoid any air bubbles. After filling the hole, repeatedly prick the adhesive steel with a needle to thicken and seal the material, if needed.

Pre-drill the hardened adhesive steel to the appropriate size according to the thread diameter. Then use a thread cutter to cut a new thread and your repaired oil pan is ready.

News

It runs like clockwork thanks to the new presto Penetrating Oil! Due to its high creeping ability, the powerful special oil penetrates into the finest...

Read more

Ideas

Scratches can be quickly repaired with presto light filler without affecting the weight of the board.

 

Also suitable for use on:

Model planes,...

Read more

You can easily even off marks and uneven areas with the one-component NC-Combi-putty.

 

Also suitable for use on:

Rubbish bins, boilers and other...

Read more