Technical Information Sheet Wheel Spray
ColorMatic wheel spray is a high-quality acrylic paint with high coverage and faster drying time. Professional broad-jet atomization provides an excellent flow and guarantees positive results.
For optimum adhesion, the aluminium wheels should be primed with ColorMatic 1K Grundierung for aluminium no. 180278. Steel wheels should be primed with ColorMatic 1K Primer Filler no. 180278.
Ideal for coating new or used car rims.
Physikalische und chemische Daten
- Basis of binder: NC
- Colour: black (no. 190353), silver satin glossy (no. 190377)
- Smell: solvent
- Degree of gloss: (at measurement angle 60° acc. to DIN 67530)
glossy: 80 gloss units
Depending on consistence and colour of the ground:
400 ml are sufficient for approx. 0,8 - 1,0 m²
Thoroughly cleaned, new or second-hand steel or aluminium wheel rim
- Drying time (at 20°C, 50% relative air humidity):
Dust-dry: after approx. 10 minutes
Dry to touch: after approx. 30 minutes
The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
- Temperature resistance: to 80°C
- Storage stability:
10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
Aerosol cans, maximum nominal volume 400 ml
- VOC-value: 273,1g
Environment and labelling
Environmentally compatible: MOTIP DUPLI is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Please mind the residue inside the containers. Completely emptied containers can be used for recycling. If cans are not emptied, they should be disposed off as "special refuse".
Labelling: All products of MOTIP DUPLI comply with the current status of their labelling regulations. Classification and distinction takes place by the presently legal form of the Globally Harmonized System of Classification and Labelling of Chemicals (GHS) or rather by CLP 1272/2008/EG regulations. Our safety data sheets comply with the current form of REACH 1907/2006/EG, article 31 und appendix II,
- Clean the surfaces to be painted thoroughly with ColorMatic silicone cleaner no. 174469, then sand
- The area must be dry and free of dust and grease
- Shake can vigorously for 2 minutes
- Carry out spray test
- For optimum adhesion before application, the aluminium wheels can be primed with ColorMatic 1K primer for aluminium no. 180 278 - steel wheels with ColorMatic 1K primer filler
- 2-3 coats
- For professional use only
- Wear an appropriate respirator (recommended type A2/P3)
Hints concerning application
Also suitable for coating exhaust tail-pipes.
|CM Felgenschwarz gl. 400||400 ml||190353|
|CM Felgensilber sdgl. 400||400 ml||190377|
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. MOTIP DUPLI is let off the liability, unless the liability-based incident is caused by a fault incurred to MOTIP DUPLI.
For any further technical questions call our hotline +49 (0) 62 66 75-266 from Monday to Thursday from 9 h a.m. to 3 h p.m. or on Friday until 12 h p.m.
As of July 26, 2010
This release replaces all eventually earlier issued versions