Technical Information Dispersion Repair Paint Available colours/order numbers Search dealer for this product Stepwise Manual General Remarks Quality and properties High covering power Odourless Water-based Protects and seals roughplaster Egalizes the colour of wall repairs Scratch-, bump and shockproof For polystyrene, wallpapers, old wall coats and gypsum Physical and chemical data Basis of the binder: Acrylic dispersion Colour: white matt Smell: odourless Degree of gloss (at measurement angle 60° acc. to DIN 67530): mat: approx. 30 gloss units Efficiency: Depending on consistence and colour of the ground: 200 ml are sufficient for up to 1 m². Drying time (at 20°C, 55% relative air humidity): Dust-dry: after approx. 30 minutes Recoatable: after approx. 3 hours The drying time depends on surrounding temperature, air humidity and thickness of the applied coat. Temperature-resistant: approx. 90 °C Storage stability: Durability 24 months, if appropriate storage provided (temperature 8°-30°C, relative air humidity 30-75%) Size: Maximum nominal volume, aerosol can 200 ml Environment and labelling Environmentally compatible: MOTIP DUPLI is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material. Disposal: Please mind the residue inside the containers. Completely emptied containers can be used for recycling. If cans are not emptied, they should be disposed off as "special refuse". Labelling: All products of MOTIP DUPLI comply with the current status of their labelling regulations. Classification and distinction takes place by the presently legal form of the Globally Harmonized System of Classification and Labelling of Chemicals (GHS) or rather by CLP 1272/2008/EG regulations. Our safety data sheets comply with the current form of REACH 1907/2006/EG, article 31 und appendix II, Using instructions The most DUPLI-COLOR spray paints have a so-called no-spray ring or a tamper-proof cap. This is to avoid unauthorized use. Please see the corresponding advises on the cap or on the label. Before use, carefully read and observe the warning texts on the label! Application Before use, shake the can for 2 minutes. The surface has to be clean and try. Drily brush water streaks, remove salt efflorescences. Initially test spray. Apply from a distance of approx. 25 cm several thin cross-coats. To increase the insulating effect, let surfaces dry. For difficult spots, repeat application if necessary. Recoatable with dispersion colours. Protect from frost. After application clean the sprayhead in order to make a further use of the spray can possible. While using dispersion repair paint, a slight bleeding in the insulating layers may occur. If this is the case, please check the insulating effect before applying the final coating. The final insulating effect is reached after complete film formation and after it has been cured. Before applying non-insulating top coats, plan 24 hours waiting time. Tips for spray painting Protect the object and the surrounding area from spray mist. Temperature should range between +10°C and +25°C, max. air humidity 60 %. Store in a dry place. Protect from direct sunlight and other sources of heat. Use only during dry weather, in places protected from the wind, and in well-ventilated rooms. Follow the warning texts on the labels! Order informations Oops, an error occurred! Code: 20190321170149b26de5d1 Disclaimer of liability This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. MOTIP DUPLI is let off the liability, unless the liability-based incident is caused by a fault incurred to MOTIP DUPLI. For any further technical questions call our hotline +49 (0) 62 66 75-266 from Monday to Thursday from 9 h a.m. to 3 h p.m. or on Friday until 12 h p.m. As of: October 18, 2017 This release replaces all eventually earlier issued versions.
Technical Information Roughcast Spray DUPLI-COLOR Roughcast Spray creates an individual surface structure, similar to a rough plaster. It is an exclusive, water-based polyurethane dispersion, which is suitable to repair and adapt a textured plastering. It can be used on misc. surfaces, such as concrete, gypsum plasterboard, sheetrock, wood etc. Can be overcoated with all dispersion paints. Available colours/order numbers Search dealer for this product Stepwise Manual General Remarks Quality and properties Quick and easy to use, perfect for wall repairs Individual surface structure, small to medium grain size Low in odour Waterbased Makes structures like roughplaster For concrete, gypsum plasterboard, sheetrock, wood, wallpaper etc. Physical and chemical data Basis of the binder: Polyurethane dispersion Colour: white matt Efficiency: 400 ml are sufficient for approx. 1,5m² Drying time (at 20°C, 45 % relative air humidity): drying after 60 minutes can be coated with all dispersions The drying time depends on surrounding temperature, air humidity and absorpitivity of the ground. Storage stability: 2 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%) Do not store below 5°C Size: 400 ml aerosol can Environment and labelling Environmentally compatible: MOTIP DUPLI is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material. Disposal: Please mind the residue inside the containers. Completely emptied containers can be used for recycling. If cans are not emptied, they should be disposed off as "special refuse". Labelling: All products of MOTIP DUPLI comply with the current status of their labelling regulations. Classification and distinction takes place by the presently legal form of the Globally Harmonized System of Classification and Labelling of Chemicals (GHS) or rather by CLP 1272/2008/EG regulations. Our safety data sheets comply with the current form of REACH 1907/2006/EG, article 31 und appendix II, Using instructions Before use, carefully read and observe the warning texts on the label! The spray creates an individual structure of the surface, similar to a roughcast. By several thicknesses and distances of spraying you can create a fine to medium graininess. Exclusive, water-based polyurethane dispersion, suitable to repair and to align roughcast. Waterproof. Suitable for inside and outside use. Suitable for application on many surfaces: concrete, gypsum plasterboard, sheetrock, wood etc. Drying 60 minutes. Overpaintable with all dispersion paints. In case of spots of water, smoke and smut we recommend, to use first DUPLI-COLOR Isolating Primer. Order information Oops, an error occurred! Code: 20190321170015a926c82b Examples for use Disclaimer of liability This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. MOTIP DUPLI is let off the liability, unless the liability-based incident is caused by a fault incurred to MOTIP DUPLI. For any further technical questions call our hotline +49 (0) 62 66 75-266 from Monday to Thursday from 9 h a.m. to 3 h p.m. or on Friday until 12 h p.m. As of April 13, 2018 This release replaces all eventually earlier issued versions.
Order informations Dispersion Repair Paint Order informations Oops, an error occurred! Code: 2019032117012282fed007 Disclaimer of liability This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. MOTIP DUPLI is let off the liability, unless the liability-based incident is caused by a fault incurred to MOTIP DUPLI. For any further technical questions call our hotline +49 (0) 62 66 75-266 from Monday to Thursday from 9 h a.m. to 3 h p.m. or on Friday until 12 h p.m. As of: October 18, 2017 This release replaces all eventually earlier issued versions. back
Roughcast Spray DUPLI-COLOR Roughcast Spray creates an individual surface structure, similar to a rough plaster. It is an exclusive, water-based polyurethane dispersion, which is suitable to repair and adapt a textured plastering. It can be used on misc. surfaces, such as concrete, gypsum plasterboard, sheetrock, wood etc. Can be overcoated with all dispersion paints. Data sheet Available colours/order numbers Search dealer for this product Stepwise Manual General Remarks Examples for use
Order informations Aqua MoTip Aqua Acryl spray paint is ECOFRIENDLY because a huge 90% of the solvents have been replaced by water. MoTip Aqua Acryl spray paint is highly suitable for painting toys, for example, because the spray paint is water-based. Its properties have been carefully tested in accordance with standard NEN-EN 71-3 Safety of toys*. This user friendly spray paint is fast-drying, has a lasting gloss and is pleasant to use thanks to the fine atomisation and the attractive spraying pattern. The paint layer is flexible and lastingly protects the surface, including against UV-light, so you can enjoy your paint results for a long time to come. This spray paint is suitable for both indoor and outdoor projects, and is ideal for painting garden furniture, garden tools, children’s room and toys. You can apply MoTip Aqua Acryl to virtually any surface, including wood, metal, card, fabric, glass, wicker, ceramic and polystyrene. The MoTip Aqua Acryl range comprises primers, a choice of colours in gloss and matt, and clear varnishes. *Awaiting certification Order informations Oops, an error occurred! Code: 201903211704234d684827 Examples for use Disclaimer of liability This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. MOTIP DUPLI is let off the liability, unless the liability-based incident is caused by a fault incurred to MOTIP DUPLI. For any further technical questions call our hotline +49 (0) 62 66 75-266 from Monday to Thursday from 9 h a.m. to 3 h p.m. or on Friday until 12 h p.m. Status: February, 2019 This release replaces all possibly earlier issued versions. back
Order informations HYBRID User-friendly laquer with little odour for various decorative applications. For treatment of metal, stone, wood, plastic, glass and textile fabric bases. Advanced spray paint technology HYBRID spray paint produces beautiful, high-gloss results. The lacquer can be applied without primer to many bases, even to polystyrene. HYBRID spray paint can easily and without any problems be applied over existing paint layers without running. Low odour HYBRID spray paint is strong and dries quickly, making it scratch-resistant. An ideal spray to help you express your creative ideas right away. Unleash your creativity! Order informations Oops, an error occurred! Code: 201903211704524f8788c8 Examples for use Disclaimer of liability This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. MOTIP DUPLI is let off the liability, unless the liability-based incident is caused by a fault incurred to MOTIP DUPLI. For any further technical questions call our hotline +49 (0) 62 66 75-266 from Monday to Thursday from 9 h a.m. to 3 h p.m. or on Friday until 12 h p.m. Status: February, 2019 This release replaces all possibly earlier issued versions. back
Order informations Insulating Primer Fast drying waterbased insulating primer spray for interior and exterior application with excellent isolation and barrier effect against many different types of stains (especially water stains) on mineral-based substrates (plaster etc.), wood and concrete. Can be painted over with all emulsion paints, alkyd-based, water-based and acrylic paints; not with two-component paints. Adjustable spray cone width (horizontally and vertically). Application area: Ideal when fastness and mobility are the primary considerations. Order informations Oops, an error occurred! Code: 201903211703008c45bbef Disclaimer of liability This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. MOTIP DUPLI is let off the liability, unless the liability-based incident is caused by a fault incurred to MOTIP DUPLI. For any further technical questions call our hotline +49 (0) 62 66 75-266 from Monday to Thursday from 9 h a.m. to 3 h p.m. or on Friday until 12 h p.m. As of March 19, 2019 This release replaces all eventually earlier issued version. back
Order informations Roughcast Spray DUPLI-COLOR Roughcast Spray creates an individual surface structure, similar to a rough plaster. It is an exclusive, water-based polyurethane dispersion, which is suitable to repair and adapt a textured plastering. It can be used on misc. surfaces, such as concrete, gypsum plasterboard, sheetrock, wood etc. Can be overcoated with all dispersion paints. Order informations Oops, an error occurred! Code: 2019032117020905c9ea69 Examples for use Disclaimer of liability This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. MOTIP DUPLI is let off the liability, unless the liability-based incident is caused by a fault incurred to MOTIP DUPLI. For any further technical questions call our hotline +49 (0) 62 66 75-266 from Monday to Thursday from 9 h a.m. to 3 h p.m. or on Friday until 12 h p.m. As of April 13, 2018 This release replaces all eventually earlier issued versions. back
HYBRID User-friendly laquer with little odour for various decorative applications. For treatment of metal, stone, wood, plastic, glass and textile fabric bases. Advanced spray paint technology HYBRID spray paint produces beautiful, high-gloss results. The lacquer can be applied without primer to many bases, even to polystyrene. HYBRID spray paint can easily and without any problems be applied over existing paint layers without running. Low odour HYBRID spray paint is strong and dries quickly, making it scratch-resistant. An ideal spray to help you express your creative ideas right away. Unleash your creativity! Data sheet Available colours/order numbers Search dealer for this product Stepwise Manual General Remarks Examples for use
