Technical Information Metal Effect Bronces
DUPLI-COLOR Metal Effect Bronce is a metallic, effectful protective coat to design and repair most different surfaces for inside use. Ideally suitable for decorative coatings in the interiour, such as picture frames, ornaments, ceiling panels, decorative items etc. Use only for mechanically not stressed objects.
Possible grounds are metal (iron, steel, zinc), paintable plastics, wood and other natural material.
Physical and chemical data
- Basis of the binder: Based on alkyd-resin
- Colour: gold, silver
- Efficiency:
approx. 1.5 m² per 125 ml can - Drying time (at 20°C, 65% relative air humidity):
Surface-dry after approx. 30 min.
Coatable after 8-10 hours.
The drying time depends on surrounding temperature, air humidity and absorpitivity of the ground. - Cleaning of tools: immediately after use with a universal thinner
- Storage stability:
5 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%) in the unopened original container.
Do not store below 5°C - Size: metal tins 125 ml
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Preparation of the ground:
- The surface has to be bearing, dry, clean and free from fat and rust.
- Thoroughly clean zinc with zinccleaner or household-cleaner with salmiakgeist.
- Remove flaking, not bearing old coatings (with a paint remover or by sanding).
- Sand down and old coatings, then test compatibility of the lacquer.
Painting:
- Before application, always carefully stir up the paint
- Temperature of the object and surrounding temperature should be at least +5°C
- Brush, roll or spray (adjust to spray viscosity)
- Top coat with this paint, apply speedy and rich, but not too thick, indiluted.
- Can be diluted with universal thinner, but we do not recommend this, as ready for processing.
- Before each coating, sand and clean after drying.
- Do not mix with other products.
- Clean tools directy after use with universal thinner.
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of May 3rd, 2018
This release replaces all eventually earlier issued versions.
