Technical Information 2K Garage Floor Paint
DUPLI-COLOR 2K Garage Floor Paint is a seal coat for protection and decoration of concrete floor surfaces exposed to moderate, medium heavy mechanical and chemical wear, e.g. garages, laboratories, warehouses, production facilities. Protection of wall surfaces that are exposed to moisture, chemicals and stronger chemical loads. It can be used for protection and decoration of walls and floors covered with ceramic tiles.
Physical and chemical data
- Basis of the binder: epoxy-coating, water-thinnable
- Smell: neutral
- Efficiency:
Depending on thickness of layer
6 kg are sufficient von 15m² - Drying time (at 20°C, 65% relative air humidity):
dust-dry: after 6-8 hours
walkable (for pedestrians): after approx. 24 hours
fully hardened: after 7 days
The drying time depends on surrounding temperature, air humidity and absorpitivity of the ground. - Cleaning of tools: immediately after use with water
- Storage stability:
2 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%) in the unopened original container.
Do not store below 5°C and over 25°C. - Size: 6 kg tin containers (component A = 4,8 kg and component B (hardener) = 1,2 kg
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
- Stir well the component A.
- After that give the component B to the component A and mix it with an electric stirring gear at low speed (max. 400 turns/min.)
- Smaller quantities can be mixed manually.
- Give little by little water (approx. 5-10% on the mixture) into the homogenious mixture.
- For thoroughly mixing, fill the mixture into another container and mix it again well.
- Mixing ratio (per cent by weight): component A : component B 80 : 20 (100 : 25)
- Pot life: 90 min. at standard conditions.
- Apply with a short-haired roller or by spraying (airless device)
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of September 7, 2018
This release replaces all eventually earlier issued versions.
