Technical Information Blocking Primer
DUPLI-COLOR Blocking Primer to isolate soilings, for example water spots, to bind humidity on mineral grounds, e.g. plaster, concrete, in cellars, garages, on facades, walls etc. in interior and exterior premises. Helps zu avoid saline bloom.
Suitable für water spots, carbon black and efflorescence.
Physical and chemical data
- Basis of the binder: modifiziertes Acrylharz
- Colour: white
- Degree of gloss (at measurement angle 60° acc. to DIN 67530):
satin matt - Efficiency:
approx. 4 - 6 m² per litre - Drying time (at 20°C, 65% relative air humidity):
dust-dry after approx. 2,5 hours
fully dried after approx. 24 hours
The drying time depends on surrounding temperature, air humidity and absorpitivity of the ground. Excessive layer thickness and missing air movement can delay the drying time. - Cleaning of tools: immediately after use with white spirit
- Storage stability:
2 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%) in the unopened original container.
Do not store below 5°C - Size: 750 ml metal tin
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
- Remove food during the working and drying time from the concerned rooms.
- Ground may be slightly humid, but it must be clean and bearing.
- Not suitable for sandstone.
- In case of durable impact of humidity the source has the be eliminated before.
- Stir well.
- Apply 1 - 2 times, the first application with a brush.
- Further coatings with a brush or roller.
- Working temperature: +8°C - +25°C.
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of March 21, 2018
This release replaces all eventually earlier issued versions.